FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: crauds on March 30, 2012, 09:56:20 pm

Title: Strange Deboarding Error: Couati Restart then Error Again **solved**
Post by: crauds on March 30, 2012, 09:56:20 pm

Parking at Gate G2 NCRG without using "followme" since since short taxiway.  Marshaller directed parking the I requested deboarding and after opening Cargo as requested, I got following popup:

Title: Re: Strange Deboarding Error: Couati Restart then Error Again
Post by: virtuali on March 30, 2012, 10:00:18 pm

It would be useful if you posted the couatl.err file mentioned in the error message. I assume that, if you haven't specified it, the airport is default with a default AFCAD ?

Title: Re: Strange Deboarding Error: Couati Restart then Error Again
Post by: crauds on March 30, 2012, 10:07:37 pm

This forum keeps disallowing me to upload the files!!!!!!!!!   Let me try again converting everything to txt!

Title: Re: Strange Deboarding Error: Couati Restart then Error Again
Post by: virtuali on March 30, 2012, 10:09:12 pm

Quote from: crauds on March 30, 2012, 10:07:37 pm

This forum keeps disallowing me to upload the files!!!!!!!!!   Let me try again converting everything to txt!

It would have been enough to simply zip them all together.

Title: Re: Strange Deboarding Error: Couati Restart then Error Again
Post by: virtuali on March 30, 2012, 10:12:49 pm

Can I assume the airport is the default one ?

Title: Re: Strange Deboarding Error: Couati Restart then Error Again
Post by: crauds on March 30, 2012, 10:15:29 pm

This forum will not post my replies.  This is my 4th attempt.  Hope it goes thru.  YES, it is default AFCAD but I modified the parking to include Small airline gates (2) and adjusted their footprints so that marshaller was not in the grass.  I have FULL install of 1.3 + both updates.

Craig

Title: Re: Strange Deboarding Error: Couati Restart then Error Again
Post by: crauds on March 31, 2012, 12:06:24 am

ISSUE RESOLVED!

Umberto, you probably would not have been able to duplicate the error unless I had sent you a copy of the modified AFCAD.  I moved the aircraft to the right to the next stand and all works perfectly.  I think the problem was that I have placed the position of GATE G2 too close to the left edge of the tarmac and there was not room enough on the left for the bus.  I will either remove the bus call for that stand or move its footprint to the right in the AFCAD.  Anyway I have resolved the issue.


Craig