FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: AlphaBravo23 on March 05, 2012, 07:29:37 pm

Title: Pushback vehicle not attached correctly
Post by: AlphaBravo23 on March 05, 2012, 07:29:37 pm

Anybody else notice that the pushback vehicle isn't connecting to an aircraft properly? When I first installed GSX I was using the default King Air and the tow bar seems to attach to the nosegear correctly but it doesn't now with the Premiere Aircraft Design Dash 8 Q202. The tow bar extends beyond the nose gear and it almost looks like the vehicle is pushing the aircraft by bumping its nose  ;D . Is this something that can be adjusted in the settings or configuration? There have been so many GSX updates that I can't see anything that I can configure but I do remember seeing something that says "customize this parking spot" or something like that. Any advice?

Title: Re: Pushback vehicle not attached correctly
Post by: marvic on March 05, 2012, 07:47:16 pm

Is your aircraft in the supported list? The post below links to the same problem with another "NON" supported aircraft. The tug can only go by what the aircraft config does.

http://www.fsdreamteam.com/forum/index.php?topic=6050.0

Title: Re: Pushback vehicle not attached correctly
Post by: AlphaBravo23 on March 05, 2012, 08:12:36 pm

Thanks for the reply. Where is the supported aircraft list? Anyway, it's not a deal breaker for me. I'm not doing videos or anything like that. Perhaps the team can address the issue on future updates.

Title: Re: Pushback vehicle not attached correctly
Post by: AlphaBravo23 on March 05, 2012, 10:24:58 pm

Found the list. I'm sure the list of supported planes will increase in time.