FSDreamTeam forum

Products Support => Hawaiian Airports support FSX/P3D => Topic started by: fltsimguy on February 03, 2012, 03:08:52 am

Title: Objects Not Showing Correctly in Hawaiian Airports **solved**
Post by: fltsimguy on February 03, 2012, 03:08:52 am

The airports look like they will be very good once I get them to work properly.

I have attached some screen shots of my problem.  Objects pop in only when very close to the Airport or do not show at all.

All airports are showing as registered in the Addon Manager.

Any ideas what is going on and how to fix this issue?  This show Kahului and Kona apt.

Honolulu looked perfect for about a minute and then all the buildings dissappeared, so it looked like it might have gone into trial mode but the addon manager does show it as active.

Help please!

Bryan

Title: Re: Objects Not Showing Correctly in Hawaiian Airports
Post by: fltsimguy on February 03, 2012, 03:11:54 am

checked Kihue and Hilo...the object start by showing in full, then then it looks like its going into trail mode.  Yet for every one of these products they show as fully registered in my menu.

Perhaps a FSX reboot is required?

Title: Re: Objects Not Showing Correctly in Hawaiian Airports
Post by: fltsimguy on February 03, 2012, 03:41:03 am

OK I think that was my issue.  I rebooted FSX after activation and have done two short hops and everything seem to be fine.

Sorry to bother you about this issue.

The airports are looking very good, thanks.