FSDreamTeam forum
General Category => General Discussion => Topic started by: sim-sim on July 27, 2011, 02:50:21 am
-
Hello!
Please help me to understand what has been happened...
I've just re-installed ZurichX to 1.5.2 version (FSX show the notification about new one) and activate serial key.
But after this I can not to see any buildings in all your your scenes!!!(( just jetways. It shows like not activate scenarios...
What is this? What I should to do?
I have also installed the new version of KSFOX 2.0 scene. May be the problem is in that installation?
Hope for your help.
-
There's a whole discussion about this in this same section, we are trying to find what it is, in the meantime, install Zurich in offline mode, with the network disconnected, it should work.
-
Ok, thanks! But how could I activate the scene without internet connection?
-
Ok, thanks! But how could I activate the scene without internet connection?
You just install it without the network, but can re-enable it after the installation. However, if you say you activated it, than it's already active.
-
Yes, it is...
But I have seen in the topic of KSFOX that the problem is in update 2.0
Everybody talks about it... So, I should to wait when you fix this problem... Isn't it?
-
Everybody talks about it... So, I should to wait when you fix this problem... Isn't it?
The temporary fix suggested there is to install another FSDT scenery with the network disconnected after KSFO.