FSDreamTeam forum

Products Support => GSX Support MSFS => Topic started by: argaeus on June 20, 2025, 08:25:48 am

Title: Setting Push Back in GSX
Post by: argaeus on June 20, 2025, 08:25:48 am

Hi,

I have been seeing this elongated arrows while preparing a push-back route at a parking spot and this started happening after latest version update couple of days ago.
I am not sure if this (and all previous) parking spots will work properly when push-back option is selected or is my airraft going to go around all this backward circular route to come to its final spot?

Any ideas why this started happening?
(http://)

Title: Re: Setting Push Back in GSX
Post by: argaeus on June 20, 2025, 09:33:51 am

This is the result! It followed the arrowed route and pushed me back into the terminal!

Title: Re: Setting Push Back in GSX
Post by: virtuali on June 20, 2025, 12:04:46 pm

I'm not sure I understand, those are the normal arrows you are supposed to see when you edit a pushback, either using the editor, or the QuickEdit function during pushback. So, when you say " while preparing a push-back route", you mean you entered in  one of the two editing modes ?

Title: Re: Setting Push Back in GSX
Post by: argaeus on June 20, 2025, 03:52:54 pm

Yes Sir,

I was trying to create profile for my scenery project but started seeing elongated arrows ONLY for LEFT push-back option whereas RIGHT option shows proper arrows and can be set properly and works as it should.

The screenshot shows the elongated arrow pattern curved and then comes back in an opposite curve to where the aircraft icon stands - this is where the aircraft should be pushed back to, not into the terminal buildings. This never happened to me when I created profile files for LTFM (as big and complicated as LTAI) and also LTFJ just recently.

Hope it is clear now.