FSDreamTeam forum
Products Support => GSX Support MSFS => Topic started by: wolfbaronx on June 19, 2025, 05:11:11 am
-
Hello team
This happens with lavatory services only any other service works fine
couatl v5.0 (build 5961)
panic log started on Wed Jun 18 19:01:18 2025
problem raised by addon <unknown>
Traceback (most recent call last):
File ".\common\fsm.py", line 73, in executeDoFuncToCompletion
File ".\GSX\assistanceServices\water.py", line 256, in do
AttributeError: 'LavatoryTruck' object has no attribute 'playerMan'
{'Airport': 'EDDL', 'User Pos': (51.29007048579057, 6.782163533142002, 40.4841 m, 3.48149 m, 322.75238010983475, 0.0012502326891072242, -0.0, 0.0038367342669720066, 3.5661599418640137, 1.0), 'Requested assistance services at': 'Apron - East III (V1-V8) | Stand V1'}
Not sure if reported before but there is no update on GSX so far.
-
It's an issue with the GSX profile that ships with the airplane.
The lavatory vehicle has a minimum height requirement of 1.80 mt from ground (height of the character + some margin) so you won't see the character head into the plane. The profile included with the airplane has set this to 1.82 mt, but with a so small margin, if the airplane is loaded a bit more, it's very easy the actual point would be lower than the minimum height required for the vehicle to be used.
This wouldn't happen with the GSX internal profile, which set the lavatory point at 1.94 mt from ground, so it has more margin to allow differences in payload to still accept the vehicle, but the way GSX works, is that data in an airplane profile supplied by the developer or edited/downloaded by users, will take precedence over the GSX internal data. If you want to use the same settings, you can edit this file:
Community\ifly-aircraft-737max8\SimObjects\Airplanes\iFly 737-MAX8\gsx.cfg
and change these lines to:
waterpos = 0.29 -13.12 -1.50
lavatorypos = -0.80 -11.50 -1.75
-
Thanks for the reply.
I checked the file for IFLY and it has exact values you put there
waterpos = 0.29 -13.12 -1.50
lavatorypos = -0.80 -11.50 -1.75
maybe you meant to change -1.75 to -1.94?
Just making sure I got what you said right
-
I checked the file for IFLY and it has exact values you put there
Sorry, I copied the "wrong" values in fact. These are the correct one, which are the same as the GSX internal values:
waterpos = 0.33 -13.15 -1.49
lavatorypos = -0.77 -11.55 -1.63