FSDreamTeam forum

General Category => Unofficial F/A-18 Acceleration Pack board => Topic started by: slipstream on August 05, 2010, 10:39:34 pm

Title: Unable to turn on ILS
Post by: slipstream on August 05, 2010, 10:39:34 pm

I select ILS / enter channel 26 / enter / type ILS code / enter / HSI select ILS / enter course hdg. The ILS remains OFF.

Any ideas where I am going wrong? Thanks in advance.

Title: Re: Unable to turn on ILS
Post by: Nike619 on August 05, 2010, 11:25:23 pm

This is the updated Hud.

ILS>Enter Freq. Thats all I have to do

Title: Re: Unable to turn on ILS
Post by: slipstream on August 05, 2010, 11:30:25 pm

But does it (ILS) not have to be on to work?

Title: Re: Unable to turn on ILS
Post by: virtuali on August 06, 2010, 12:02:38 am

First, check that you selected the correct X or Y channel. And, you need put the HSI in ILS mode.

Title: Re: Unable to turn on ILS
Post by: slipstream on August 06, 2010, 09:12:54 am

Thanks so far. Ah, you mention selecting the X or Y channel. Thanks. The tutorial below does not mention that.

Title: Re: Unable to turn on ILS
Post by: virtuali on August 06, 2010, 12:26:11 pm

Yes, because on that tutorial, the ILS was selected by typing the frequency. If you type the frequency, the airplane will automatically figure out the correct Channel and X or Y.

If, instead, you use the Channel (perhaps, because you have a military map), you need to be careful if it's X or X.

Title: Re: Unable to turn on ILS
Post by: slipstream on August 06, 2010, 02:10:06 pm

Right, the plot thickens. I entered 1105 for EGSS. If I entered 110500 I receieved an error.

Title: Re: Unable to turn on ILS
Post by: virtuali on August 06, 2010, 03:09:50 pm

You can't enter 6 digits, the maximum is 5 so, either you enter 1105, or you enter 11050, not 110500