FSDreamTeam forum
Products Support => GSX Support MSFS => Topic started by: Jerrymc3 on January 23, 2024, 11:52:17 pm
-
I flew from Sydney to Brisbane (ORBX) today and as I was taxiing to the gate I tried to open gsx to select a gate but it would not open. I parked at gate 22 but it still would not open. I worked fine at Sydney.
-
- Choose "Restart" from the Couatl icon in the Tray notification area
- Allow a few seconds to start and, if the airport profile (assuming you use one) has many VGDS to create, it might be more than a few seconds.
- Open the menu after it should have completed the restart.
-
Do I need to run the FSDreamteam Update any time I install a new airport?
-
Do I need to run the FSDreamteam Update any time I install a new airport?
You don't have to *perform* an actual GSX update (if there's no need for it) but yes, you must at least start the FSDT Installer, and run the "Exclude 3rd party" routine, to be sure the new airport will be Disabled from GSX jetway replacement, and if it's not conforming to the official naming standard (so it wasn't recognized automatically), add its code manually in that page and Apply the changes.
Yes, performing an Update will do that as well but, it will be slower (if you don't need to update GSX), and it will miss airports with non-confirming names (usually freeware), which must always be added manually.