FSDreamTeam forum
Products Support => GSX Support FSX/P3D => Topic started by: raam123 on January 01, 2023, 01:04:59 am
-
Hi,
Since latest updates (can remember which one...) when requesting pushback the locking pin and unlocking pin is below the plane... Agent keep going there instead of the nose gear location.
Although all other procedure looks right... How to fix it back ?
(https://i.postimg.cc/6y151nN2/2023-1-1-1-55-45-779.png) (https://postimg.cc/6y151nN2)
(https://i.postimg.cc/xXwj9Q89/2023-1-1-1-58-26-633.png) (https://postimg.cc/xXwj9Q89)
(https://i.postimg.cc/5XYNcyxP/2023-1-1-2-0-1-446.png) (https://postimg.cc/5XYNcyxP)
-
Anyone ?
-
Remove CS757 and try the QW757 instead. CS stopped developing FSX/P3D products as they won't update any FSX/P3D products anymore. Don't support CS and instead boycott CS in favor of QW.
-
Remove CS757 and try the QW757 instead. CS stopped developing FSX/P3D products as they won't update any FSX/P3D products anymore. Don't support CS and instead boycott CS in favor of QW.
Your solution to every problem is just to buy another airplane instead? I do believe systems wise, the CS 757 simulates more than the QW 757, as the QW 757 originally started out as a mid-level product until they added a little more complexity to it, but it's still limited in what you can do.
-
The solution isn't removing plane...
I'm sure it must be a simple fix for GSX to recignize the nosewheel location for the ground agent it self....
Again pushback is perfect... the only probelm is the ground personal who goes under plane to place or remove the nosewheel pin...
It is CS757,CS767 problem....
-
Have you tried to edit the Bypass pin location ? GSX surely recognize the front gear location in every airplane and, if the Bypass pin location is unedited, it won't use and will use only the front gear location. However, if the Bypass pin location is edited, even slightly, GSX will see it has been edited, and it will use that, so it must be correct, otherwise it will default to 0,0,0, that is the airplane center.
-
Have you tried to edit the Bypass pin location ? GSX surely recognize the front gear location in every airplane and, if the Bypass pin location is unedited, it won't use and will use only the front gear location. However, if the Bypass pin location is edited, even slightly, GSX will see it has been edited, and it will use that, so it must be correct, otherwise it will default to 0,0,0, that is the airplane center.
Sorted,
I just added the bypass pin location.
Thank you.