FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: Ray Proudfoot on October 14, 2022, 03:26:28 pm

Title: P3Dv5 - Couatl crashes when enabling Marshall readout.
Post by: Ray Proudfoot on October 14, 2022, 03:26:28 pm
Umberto, I enabled the marshaller readout whilst approaching the gate. Couatl immediately crashed. I was able to restart it. Something you might want to look at.

P3D v5.3 HF2.
Title: Re: P3Dv5 - Couatl crashes when enabling Marshall readout.
Post by: virtuali on October 14, 2022, 03:29:42 pm
Do you have an error log ?
Title: Re: P3Dv5 - Couatl crashes when enabling Marshall readout.
Post by: Ray Proudfoot on October 14, 2022, 03:33:16 pm
Quote from: virtuali on October 14, 2022, 03:29:42 pm
Do you have an error log ?

I’ll check and get back to you.
Title: Re: P3Dv5 - Couatl crashes when enabling Marshall readout.
Post by: Ray Proudfoot on October 14, 2022, 03:58:59 pm
The original log was replaced when I restarted Couatl.

However, I setup the scenario and slewed slowly to gate D9 at PHDX (FB airport). I turned the option on and within a few seconds Couatl crashed and asked if I wanted to see the log. Here it is.
Title: Re: P3Dv5 - Couatl crashes when enabling Marshall readout.
Post by: virtuali on October 14, 2022, 04:36:14 pm
You can't enable the Marshaller Readout after you activated a Gate that is, after the Marshaller was already created. We can remove the error, but the readout would still require a Couatl restart to be active.
Title: Re: P3Dv5 - Couatl crashes when enabling Marshall readout.
Post by: Ray Proudfoot on October 14, 2022, 04:59:58 pm
Quote from: virtuali on October 14, 2022, 04:36:14 pm
You can't enable the Marshaller Readout after you activated a Gate that is, after the Marshaller was already created. We can remove the error, but the readout would still require a Couatl restart to be active.

Okay, understood. I remembered I hadn’t activated that option when I was moving towards the gate. A one-off in all probability as it will now stay enabled.

I did notice the readout was too high. Can you lower it to the middle of the screen please?