FSDreamTeam forum

Products Support => GSX Support MSFS => Topic started by: rogermoore on September 04, 2022, 02:34:51 pm

Title: -0.0 0.0 MT
Post by: rogermoore on September 04, 2022, 02:34:51 pm: Why do i see -0.0 0.0 MT flying above the gate after using the editor?

i have seen this at various airports

and, any ideas how one might get rid of it??

many thanks
Title: Re: -0.0 0.0 MT
Post by: Pirateinparadise on September 04, 2022, 06:54:29 pm: That is the Marshaller Distance Readout.

-0.0 0.0 was a great parking job.

The 1st number is distance from the stop point. I believe a negative means you stopped too early, and a positive number means you went too far. I might have that backwards. The 2nd number is the deviation left(-) or right(+) of the center line (assuming that the parking spot itself aligns with the actual line on the ramp).
Title: Re: -0.0 0.0 MT
Post by: rogermoore on September 04, 2022, 07:24:59 pm: Well I can’t take credit for the parking as I only spawned at the gate

Why is it still showing when not in editor. Is it an option somewhere do you know?
Title: Re: -0.0 0.0 MT
Post by: Turok144 on September 05, 2022, 12:43:08 am: I see the numbers too from time to time but I haven't taken note whether it's a default or 3rd party airport.
Title: Re: -0.0 0.0 MT
Post by: Phil7789 on September 05, 2022, 02:07:40 am: Quote from: rogermoore on September 04, 2022, 07:24:59 pm
Well I can’t take credit for the parking as I only spawned at the gate

Why is it still showing when not in editor. Is it an option somewhere do you know?

In GSX settings there is an option "Marshaller readout" which should disable it.
Title: Re: -0.0 0.0 MT
Post by: virtuali on September 05, 2022, 03:10:23 pm: Restart Couatl after using the editor, sometimes not all objects used by the editor can be cleared in time while the editor closes.