FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: coleferguson88 on February 11, 2021, 09:54:18 am

Title: GSX LVL 2 JETWAY SNAP
Post by: coleferguson88 on February 11, 2021, 09:54:18 am

This happens when i initiate the jetways tot the aircraft and no pause on task switch isnt on

Title: Re: GSX LVL 2 JETWAY SNAP
Post by: virtuali on February 15, 2021, 06:22:44 pm

Does it happen with a specific combination of airport, airplane or jetway ?

Title: Re: GSX LVL 2 JETWAY SNAP
Post by: coleferguson88 on February 15, 2021, 06:29:13 pm

Quote

Seems to be happening with all default airports and MFSG YPPH

Does that airport is the only one you have that comes with SODE jetways ?

Quote

at all other payware airports it says, NO sode jetways detected you will not see passengers visually

This is what is supposed to say if the airport doesn't have any kind of SODE jetway ( replaced by GSX or supplied by the scenery ), so it means the scenery comes with its own standard jetways, which are not automatically replaced by GSX, so GSX is correctly telling you these jetways won't be controlled by GSX and passengers won't use them.

Title: Re: GSX LVL 2 JETWAY SNAP
Post by: ewann on February 16, 2021, 01:52:33 am

I have this exact problem but cant seem to fix it

Title: Re: GSX LVL 2 JETWAY SNAP
Post by: FightingRaven on February 17, 2021, 03:56:10 pm

I have this problem too at flytampa schiphol with the pmdg 777 both 200 and 300 variants

Title: Re: GSX LVL 2 JETWAY SNAP
Post by: virtuali on February 17, 2021, 03:58:38 pm

Are you sure your airplane doors are all in the correct place ? Check with the GSX editor, and see if all passenger doors are set correctly, both in position and heading.

Title: Re: GSX LVL 2 JETWAY SNAP
Post by: FightingRaven on February 17, 2021, 04:25:34 pm

I have just done that again, and they are 100% correct