FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: thebettercp on December 17, 2019, 05:47:33 am

Title: GSX Parking System Editor
Post by: thebettercp on December 17, 2019, 05:47:33 am
Hello-

I am using P3D and GSX level 2. I am trying to editor parking locations and replace the marshaller with the safedock systems at select gates. However, the safedock is positioned to high on the wall. I am trying to use the 'Z' key to lower the object however it does not recognize it. the 'Q' key allows the object to go up. any ideas?
Title: Re: GSX Parking System Editor
Post by: Beat578 on December 17, 2019, 07:03:56 am
do you have an addon that took the keys? Most likeli some other addon has taken over control over those keys needed.
Title: Re: GSX Parking System Editor
Post by: thebettercp on December 18, 2019, 03:32:40 am
Doesn’t seem to be the issue. No addons use ‘Z’
Title: Re: GSX Parking System Editor
Post by: Beat578 on December 18, 2019, 07:31:27 am
Quote from: thebettercp on December 18, 2019, 03:32:40 am
Doesn’t seem to be the issue. No addons use ‘Z’

Then try to reset the "slew" commands in prepar3d by reentering them. Or you have changed the keyboard layout by accident? That's all that comes into my mind that could affect this.
Title: Re: GSX Parking System Editor
Post by: eremusfly on March 18, 2020, 03:04:00 pm
Same problem here: Q works, Z doesn't
Title: Re: GSX Parking System Editor
Post by: virtuali on March 18, 2020, 03:09:13 pm
GSX doesn't use any specific keys, or try to read the keyboard directly. It will use whatever key is currently mapped to the Slew Events in the simulator. In the case of what is *commonly* mapped to the Z key, GSX will use what is currently mapped to the "Slew Down (slowly)" command in the Controls Page and, this Event can be either:

- Used by another Add-on. Check that.

OR

- Changed or disabled by yourself using the Slew section of the Controls page.

OR

- Be different in some countries ( German keyboard have the Y and Z keys reversed )