FSDreamTeam forum
Products Support => GSX Support FSX/P3D => Topic started by: rick66 on November 02, 2019, 02:50:10 am
-
I`m trying to figure out why the tug always seems to connect in the wrong area(see pic) in the P3dv4.5 simobjects airplanes folder under 787-10 i see a gsx cfg, i also see in Virtuali folder in Appdata roaming airplanes there is also a gsx cfg file, so which one will gsx read when i call for push back? the 787-10 gsx cfg i`m using was from the users share area here on the forums.
https://i.imgur.com/F4cowTG.jpg (https://i.imgur.com/F4cowTG.jpg)
-
I`ve sorted it out.. marked solved.
-
In any case, for future reference, GSX will read the aircraft configuration from all these sources, in order of priority:
1) If there's no configuration data at all, it will read from Simconnect and the aircraft.cfg. This is not ideal, since doors positions won't be very accurate, but it's a start to create a custom config.
2) If there's an old intelliscene.cfg file made for AES by the airplane developers, it be will be used by preference over #1
3) If the airplane is internally supported by GSX, the internal configuration will be used by preference over #2
4) If the airplane comes with a GSX.CFG file, in its own folder ( the one that contains the aircraft.cfg file too ), which is usually supplied by the airplane developer, it be will be used by preference over #3
5) If the airplane has a GSX.CFG file in %APPDATA%\GSX\Airplanes, which is usually created when you edit the airplane with the GSX airplane configuration page, it be will be used by preference over #4
The GSX airplane configuration page will indicate from which source GSX is reading its data from.