FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: rowcoach on September 29, 2019, 05:19:06 pm

Title: GSX Level 2 and P3D not recognizing stock parking
Post by: rowcoach on September 29, 2019, 05:19:06 pm

Good morning,

I’m parked at TIST. It’s a stock P3D airport as far as I can tell. I’m parked at one of the gates. When I push CTL F12, the GSX menu comes up giving me the available parking spots. If I pick one of the gates, GSX sends me to somewhere on the taxiway or out on the water. I haven’t installed an add on airport for TIST, so I’m not sure what is going on.

Is there a way to get GSX to recognize the same gates that P3D is using?

Thank you,

Colin

Title: Re: GSX Level 2 and P3D not recognizing stock parking
Post by: Beat578 on September 30, 2019, 06:48:24 am

you have to go into the GSX config and take a look at the AFCAD file used. I would think that it is not the same that prepar uses. mabe one of a AI addon or something, so if they are not identical, the locations could be different.