FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: BillGradwell on September 03, 2019, 09:55:06 pm

Title: EGLC EDlevation Problem
Post by: BillGradwell on September 03, 2019, 09:55:06 pm

Hello Dream Team

Have a problem with the new ORBX EGLC airport - all GSX vechiles and crew are submerged into the apron

Have run updates but no change

Please advise resolution

Best Regards
Bill Gradwell

Title: Re: EGLC EDlevation Problem
Post by: air_jordan on September 04, 2019, 09:42:06 pm

Try this - search for any duplicate EGLC.bgl afcads and rename them thus - EGLC.bgl.off. it's not unusual to have one or more. Hope this helps

Title: Re: EGLC EDlevation Problem
Post by: BillGradwell on September 04, 2019, 09:49:16 pm

Hello Jordan

See attached. what would deemed duplicate bgl

Thanks for your help

Regards Bill

Title: Re: EGLC EDlevation Problem
Post by: air_jordan on September 05, 2019, 12:22:41 am

No these files are all fine and should be left alone. I'm no expert but from within the sim open the GSX menu and click the last option "customise aircraft position" or some such, this opens the editor and in the top left corner it'll tell you the name and location of the afcad in use by GSX, it should point to your orbx dir, if it doesn't then there's your culprit. If it does then at the top right of the same window is a small icon you can click to match the airport elevation, see if that works.

Title: Re: EGLC EDlevation Problem
Post by: virtuali on September 05, 2019, 11:09:54 am

Quote from: BillGradwell on September 03, 2019, 09:55:06 pm

Have a problem with the new ORBX EGLC airport - all GSX vechiles and crew are submerged into the apron

Try to click the small airplane icon next to the "Airport Elevation" option in the GSX scenery customization page, this usually fix a lot of elevation conflicts in sceneries.

Title: Re: EGLC EDlevation Problem
Post by: BillGradwell on September 05, 2019, 11:25:10 am

Thank you so much for the replies.
Going to try your suggestions.

Will let you know if it works.

 Best Regards
Bill Gradwell

Title: Re: EGLC EDlevation Problem (Resolved)
Post by: BillGradwell on September 05, 2019, 07:31:44 pm

Hello Everyone

Yes indeed it works and I learnt something as well.

Much obliged

Regards Bill Gradwell