FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: Jerrymc3 on January 17, 2019, 02:29:07 am

Title: GSX Elevation Problem
Post by: Jerrymc3 on January 17, 2019, 02:29:07 am

I flew into ORBX PAKT for the first time today.  I opened GSX and chose Gate 1 and  the marshaller was a 100' high and not anywhere near the gate.  I chose Gate 3 and he was floating above the Terminal.  There was also an Alaskan Airlines tail sticking out of the concrete beside my plane. I tried using the FTX Elevation Configuration tool but PAKT wasn't in the list.  Is there a way to fix this?

Jerry

Title: Re: GSX Elevation Problem
Post by: virtuali on January 17, 2019, 05:45:35 pm

GSX has a way to fix these problems, by entering the parking customization page and clicking on the small airplane icon where it says "Ground Elevation", this will read the current elevation from the sim, and would fix the floating jetways.

Title: Re: GSX Elevation Problem
Post by: Jerrymc3 on January 17, 2019, 08:09:53 pm

The only jetway isn't GSX, it may not even be removable.  The marshaller and pushback vehicle was mainly what I was concerned about but I will check into customizing the parking and see what happens.  Thanks

Jerry

Title: Re: GSX Elevation Problem
Post by: Jerrymc3 on January 18, 2019, 01:51:59 am

The Ground Elevation correction worked but I wasn't able to remove the jetway.  Apparently its part of the building.  My next flight is to Orbx Juneau, I wonder if it has the same issue.

Jerry

Title: Re: GSX Elevation Problem
Post by: SimPat on January 19, 2019, 02:43:36 am

Thanks for the Fix. It solved my Floating Jetway problem. I guess I didn't see the plane icon in the manual.