FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: Jerey on December 15, 2018, 07:07:26 pm

Title: Problem with jetway
Post by: Jerey on December 15, 2018, 07:07:26 pm

Hello ,
I tried to change one of my jetway with GSX 2 and the GSX control panel but I have a problem , the thing is that the jetway Is too low and dont’t connect with the wall were the passengers supposed to come from. Is there any possibilities for me to put the jetway in a good spot in fact to make it go up ?
Thanks !

Title: Re: Problem with jetway
Post by: Pirateinparadise on December 16, 2018, 04:39:51 pm

There are jetways of different heights in GSXL2. Go into the "Customize parking" editor, use the <F4> key as needed until the jetway is orange, and then press <F5> (next jetway) or <F6> (previous jetway) to cycle through them until you get one that is the correct one for the building. So far, I've always found one that works.