FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: Fardel on September 23, 2018, 11:58:53 am

Title: Jetway fine position
Post by: Fardel on September 23, 2018, 11:58:53 am

I read the manual but I could not know if there is the possibility of being able to move vertically only the initial part of the Jetway or of the bridge; in order to align the jetway (as a whole) with any previously prepared positions of the various scenarios.
Thank you

Paolo

Title: Re: Jetway fine position
Post by: virtuali on September 23, 2018, 06:28:20 pm

The height cannot be set, and the reasons has been answered here:

http://www.fsdreamteam.com/forum/index.php/topic,18161.msg128163.html#msg128163

The Jetways we provided have different heights (Thyssen are higher than JBT) and we have two versions of the corrugated bridge, the ones with the names ending in _S are "slanted", which should ease matching the lower height JBTs with higher terminal buildings.

With the next update, we'll include a new set of JBT-syle which will be higher than the ones initially supplied, and we'll likely continue to add new variations, to make design easier.

Title: Re: Jetway fine position
Post by: Fardel on September 23, 2018, 08:01:28 pm

Ok thank you for your replay. I wait for new update.

Paolo