FSDreamTeam forum
Products Support => GSX Support FSX/P3D => Topic started by: OnDemand888 on September 18, 2018, 12:09:25 pm
-
Before update I used gsx with 787 qw and used 3 trucks, one bulk and 2 with containers, and they worked just fine. Yesterday I needed to fully reinstall all windows system. After finishing installing the sim with addons, I entered the same gsx.cfg entries as last time I used it, and started the simulation. 2 trucks are working well, but the third, bulk, just standing there and not moving. How can I fix it?
[aircraft]
nosegear = 24.02
refueling = 0
iscargo = 0
trafficcones = 1
preferredexit = 0
wingrootpos = 3.01 3.23 0.49
wingtippos = 26.89 -10.32 3.00
fuelpos = -16.94 -2.30 1.50
waterpos = -0.01 -20.02 -1.32
lavatorypos = -0.01 -8.57 -1.91
engine1pos = -9.95 5.58 -1.35
engine2pos = 9.95 5.63 -1.33
engine3pos = 0.00 0.00 0.00
engine4pos = 0.00 0.00 0.00
[exit1]
pos = -2.13 23.14 0.58 9.00
code = 1
name = Door L1
[exit2]
pos = -2.60 11.08 0.58 -1.00
code = 2
name = Door L2
[exit3]
remove = 1
[exit4]
pos = -2.39 -19.53 0.64 -8.70
code = 4
name = Door L4
[service1]
pos = 2.46 23.15 0.65 -9.50
code = (L:DoorR1, bool)
name = Door R1
[service2]
pos = 2.80 11.21 0.57 0.10
code = (L:DoorR2, bool)
name = Door R2
[cargo1]
pos = 1.77 18.54 -1.24 -0.80
code = 4
name = Forward Cargo Door
uldcode = AKE
[cargo2]
pos = 1.71 -13.21 -1.24 -0.80
code = (L:QW_CargoDoor_Aft, enum)
name = Aft Cargo Door
uldcode = AKE
[cargomain]
pos = -1.54 -17.63 -1.29 -12.00
code = (L:QW_CargoDoor_Bulk, bool)
name = Bulk Cargo Door
uldcode = BELT
-
Here is the screenshot, and as you see, the third truck is spacing out.
P.S. and after some time the baggage unloadind progress stuck at 67%.
-
You cannot use a conveyor belt in place of the main cargo loader. The main cargo loader works only with the high cargo loader, on a cargo door which at least 1.92 meters high and with an ULD code (so no belt loaders),
-
You know, after some time I founded, that there is no issue with bulk and its just waiting for bus to end its work, or just for all passengers to load. and because it takes about 20 minutes, I thought its stuck. Is where a way to manage timings, so the truck will not wait?
-
its just waiting for bus to end its work, or just for all passengers to load. and because it takes about 20 minutes, I thought its stuck. Is where a way to manage timings, so the truck will not wait?
You can raise the Passenger Density slider, which will speed up boarding/deboarding. With some fps cost, of course.