FSDreamTeam forum
Products Support => GSX Support FSX/P3D => Topic started by: peter-andrew on September 14, 2018, 03:04:04 pm
-
Hello, I fly with GSX since a long while and I'm an Happy GSX user on P3D4.329. Few days ago I updated with version 2, without buying the extension. First it worked OK. I modified a jetway at KDEN (flightbeam) and it worked OK. Then I modified 6 jetways and all the modified jetways disapeared. I get an error on coualt. I uninstalled and re installed the addon manager and the flightbeam scenery several time without any success.
Now my situation is the following:
1- I don' have any more the new fsdt panel to exclude BGL
2- Coualt does'nt work any more at KDEN and GSX can't be started
3- GSX works only for pushback at KIAD ( flightbeam) and at some other airports I can test
4- Below the error messages:
couatl v3.2 (build 4043)
panic log started on Fri Sep 14 14:45:12 2018
problem raised by engine or unspecified addon
{'Airport': 'KDEN', 'User Pos': (39.85340833492477, -104.67666666664333, 1657.82 m, 2.45372 m, 0.6269507205744029)}
Error: exception CREATE_OBJECT_FAILED in call AICreateSimulatedObject param #1 'FSDT_SODE_JW_TB_2_5_LOGO_UAL'
{'Airport': 'KDEN', 'User Pos': (39.85340833492477, -104.67666666664333, 1657.82 m, 2.45372 m, 0.6269507205744029)}
Added GSX customized bgl jetway for Gate A 24
How can I make a clean re install of GSX?
Any comments and suggestions would be appreciated.
Happy Flying
-
Do your remember what you did ?
The error indicates GSX cannot find the log and, in fact, the logo _UAL doesn't exists, because its code is _UA. I checked now, and if I set the UA livery from the logo selection page, it saves the jetway with an _UA logo, not UAL.
I also tried setting both the airline code and the jetway airline code to UAL, but the jetway logo is still correctly saved as UA. Please indicate all your settings:
- The airline codes for that parking
- The jetway airline codes for that parking
- If a code for Virtual airlines in the GSX - Settings -> Simulation page, and which code is.
-
Thank you Umberto for your answer.
You are right, I tried to named my modified jetway with an improper name and I messed up everything. Unfortunately, I didn't write down what I have done. I get GSX working again at KDEN by switching off KDEN fbeam in: ProgramData/Virtuali/Coualt/prepar3dv4/scenery.cfg ; but, as GSX doesn't take into acount the right AFCAD, pushback is very inaccurate.
Can you please tell me how to remove my previous modifications and how to go back to a clean install of GSX and KDEN ( what files version and where ...).
-
Can you please tell me how to remove my previous modifications and how to go back to a clean install of GSX and KDEN ( what files version and where ...).
- Remove the .INI file for KDEN in this folder:
%APPDATA%\Virtuali\GSX
- If you modified any files in our jetways folders, just run the Live Update, it should restore everything.
-
It works :D
Many thanks