FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: keino333 on September 10, 2018, 05:46:58 am

Title: GSX elevation offset at default airports
Post by: keino333 on September 10, 2018, 05:46:58 am

Umberto,
can u advise


I tried setting new jetways in place of Ctrl J jetways and im have an elevation issue
https://i.imgur.com/L4uMCqM.png (https://i.imgur.com/L4uMCqM.png)

Title: Re: GSX elevation offset at default airports
Post by: virtuali on September 10, 2018, 10:56:10 am

Have you installed something from OrbX that has changed the elevation ? If yes, could you please check the name of the AFCAD used by GSX ?

Title: Re: GSX elevation offset at default airports
Post by: keino333 on September 10, 2018, 02:15:03 pm

That was it....looks like I have to make sure to manually run Vector at these airports.  The good thing is this will correct alot of airports that are placed in a valley that have resulted in running vector automatically (globally)

Title: Re: GSX elevation offset at default airports
Post by: virtuali on September 10, 2018, 02:45:37 pm

The way you describe it, seems to indicate OrbX STILL haven't updated their AEC utility to recognize sceneries installed in the proper P3D4 way, by means of an add-on.xml file.

After all this time, when this issue was very well known, more than a year after P3D4 release ? If WE did something like that, people would *crucify* us...

Title: Re: GSX elevation offset at default airports
Post by: BillS511 on September 12, 2018, 04:37:35 am

Quote from: virtuali on September 10, 2018, 02:45:37 pm

The way you describe it, seems to indicate OrbX STILL haven't updated their AEC utility to recognize sceneries installed in the proper P3D4 way, by means of an add-on.xml file.

After all this time, when this issue was very well known, more than a year after P3D4 release ? If WE did something like that, people would *crucify* us...

KSTL St.Louis jetways were elevated until I manually disabled it in Orbx AEC.