FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: Capbat on February 18, 2018, 07:42:20 pm

Title: GSX Aerosoft CRJ-700 Baggage Container.
Post by: Capbat on February 18, 2018, 07:42:20 pm

Hi All.

I have GSX and Aerosoft CRJ-700 on P3D v3.
As you can see, in the image below the container obviously visible from the outside of the aircraft while moving back to the door where it is also to big to
get out of. The container is visible while moving and only on the port side of the A/C.
From what I can understand it is either that:
- One it is to big. (Probably the cause because it does not fit the door)
- Two it is not well centered.
- Three there is a configuration somewhere that I missed.
- Four All of the above.  ;)

If someone knows (including GSX and Aerosoft) it would be nice to share.

Thanks.


(http://cxa.supersonic-online.net/CXA156/GSX CRJ700 Bagage Container Problem.jpg)
This has also been sent to Aerosoft/CRJ Forum.

Title: Re: GSX Aerosoft CRJ-700 Baggage Container.
Post by: virtuali on February 19, 2018, 01:09:55 pm

The default configuration we included with GSX doesn't specify a container: you are supposed to two normal luggage belt loaders. So, if you see a container, it means you either tried to edit the airplane configuration, and made some kind of mistake, or you downloaded a wrong GSX.CFG file.

In both cases, either user-edited configs, and downloaded configs, will both override the internal GSX configuration.

The airplane configuration page in GSX will tell you from which source GSX is taking its data from.