FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: chumley on December 14, 2016, 12:28:19 pm

Title: Aerosoft A319
Post by: chumley on December 14, 2016, 12:28:19 pm

When using this aircraft I have noticed the rear hold baggage loader not square to the side of the aircraft. This results in the baggage container entering the hold at an angle and as it passes out of sight from the doorway it suddenly reappears breaking the side of the aircraft fuselage before disappearing.

I am using the stock loading points. Is this normal or can it be adjusted?

Thanks

Title: Re: Aerosoft A319
Post by: virtuali on December 15, 2016, 09:44:35 am

Quote from: chumley on December 14, 2016, 12:28:19 pm

I am using the stock loading points. Is this normal or can it be adjusted?

Of course it can, since you can edit the heading of a door too, using the included GSX airplane configuration editor.

However, since of the rather small size of the plane, it's possible that you might have conflict with other vehicles (like catering), since I guess there was a reason why we configured it like that.