FSDreamTeam forum

General Category => General Discussion => Topic started by: lennie on June 24, 2015, 07:58:00 pm

Title: FSX slider setting for KJFK
Post by: lennie on June 24, 2015, 07:58:00 pm

Hi everyone, I am new here having just bought 5 airports last week. Have only taken a look at ORD and JFK for a circuit around both fields. ORD seems ok, but JFK has no taxiway or r/w markings. i suppose i need to adjust something? If someone can suggest I would greatly appreciate it!

I have ORBX global, vector and mesh installed.

Thanks!

Lennie

Title: Re: FSX slider setting for KJFK
Post by: virtuali on June 24, 2015, 10:17:02 pm

You have the whole airport correct (buildings, etc. ) but are missing JUST the markings ? That looks like a conflicting mesh, which is covering the ground OR a conflicting AFCAD with a different altitude.

Title: Re: FSX slider setting for KJFK
Post by: lennie on June 25, 2015, 03:04:27 pm

Thanks. I need to check the other 3 airports that I bought. But I have no idea what to do in order to correct JFK - I will look at it again. Maybe uninstall, and install again?

Title: Re: FSX slider setting for KJFK
Post by: virtuali on June 25, 2015, 03:06:49 pm

Quote from: lennie on June 25, 2015, 03:04:27 pm

Maybe uninstall, and install again?

I doubt this would make any difference, unless the actual scenery files got corrupted/missing on your system. If the problem is caused by a conflicting scenery, you must act on it. But of course, you must first find which one is causing the conflict.

Title: Re: FSX slider setting for KJFK
Post by: lennie on June 26, 2015, 02:49:55 am

Had a message pop up today while landing on 35L at DFW. As soon as i was on the r/w I was immediately 10+m over the r/w. message said something about downloading addon manager and do an up date so I will try this next. Thanks for your help!