FSDreamTeam forum

Products Support => GSX Support FSX/P3D => Topic started by: JesterGoose on November 28, 2014, 05:33:55 am

Title: P3D 2.4 wont run after GSX install **SOLVED**
Post by: JesterGoose on November 28, 2014, 05:33:55 am

P3D starts then stops with the following error box displayed. Am using the latest installer (1.9), same error with earlier installer. Uninstalled GSX prepar3D executes and runs fine.

Any thoughts on the problems?

(http://[URL=http://s1274.photobucket.com/user/FlyPiper/media/GSXerror_zpsf4fcf94b.jpg.html][IMG]http://i1274.photobucket.com/albums/y423/FlyPiper/GSXerror_zpsf4fcf94b.jpg)[/URL][/img]

Title: Re: P3D 2.4 wont run after GSX install
Post by: JesterGoose on November 28, 2014, 05:38:06 am

Cant get the image to show on previous post the error box title is
 "The Enigma Protector" and the message is

"Internal Protection Error, please contact the author!"

Don't know if its a P3D error or GSX

Title: Re: P3D 2.4 wont run after GSX install
Post by: eyecandy on November 28, 2014, 10:47:38 am

Same problem!  :'(

Title: Re: P3D 2.4 wont run after GSX install
Post by: virtuali on November 28, 2014, 11:09:55 am

That's very strange. I don't get any error, see the attached screenshot, which shows GSX 1.9 deicing the default Lockheed Constellation under P3D 2.4, at FSDT Geneva.

The usual suggestions should apply:

- Turn off the antivirus, and configure it to exclude P3D\bglmanx.dll and P3D\fsdreamteam\Couatl\Couatl.exe files from scanning

- Don't use the P3D Migration Tool.

Title: Re: P3D 2.4 wont run after GSX install
Post by: eyecandy on November 28, 2014, 11:45:25 am

Thank You!

The P3D Migration Tool caused the problem

Title: Re: P3D 2.4 wont run after GSX install **SOLVED**
Post by: JesterGoose on November 28, 2014, 10:30:31 pm

I don't use Migration tool, nor ever had it installed.