FSDreamTeam forum

General Category => General Discussion => Topic started by: christiaan on May 26, 2014, 11:42:07 pm

Title: FlightBeam KDEN V1.2 install
Post by: christiaan on May 26, 2014, 11:42:07 pm

Have a lot of FSDT airports & from FlightBeam.

I am going to un-install KDEN Version 1 and install the new 1.2 (demo) version.

I presume I have to register the airport scenery again in the FSX Add-On programme.

As I do not want any issues, if asked to remove Add-on Manager & Coult can I ignore this message?

I do not want to mess up the airports installed.

Please advice.

Title: Re: FlightBeam KDEN V1.2 install
Post by: Bruce Hamilton on May 26, 2014, 11:45:58 pm

Be easier to grab the manual patch from the forum...

Title: Re: FlightBeam KDEN V1.2 install
Post by: virtuali on May 27, 2014, 11:16:52 am

Quote from: christiaan on May 26, 2014, 11:42:07 pm

I presume I have to register the airport scenery again in the FSX Add-On programme.

No, you will not. That's what the installer is for.

Quote

As I do not want any issues, if asked to remove Add-on Manager & Coult can I ignore this message?

You usually WANT to ignore the message, especially considering you have other products requiring the modules because, the message will also warn you that if you remove the modules, no products requiring them will work.

You reply YES to the removal question, when you need to do a clean reinstall for troubleshooting reasons.

Title: Re: FlightBeam KDEN V1.2 install
Post by: christiaan on May 27, 2014, 02:10:30 pm

Thanks Virtuali,

Followed your advice.

Got the new version installed very quickly & easy.

Title: Re: FlightBeam KDEN V1.2 install
Post by: juniormafia27 on May 31, 2014, 04:52:14 am

Where do you see KDEN v1.2?

Title: Re: FlightBeam KDEN V1.2 install
Post by: Frank Lindberg on May 31, 2014, 10:24:13 pm

Quote from: juniormafia27 on May 31, 2014, 04:52:14 am

Where do you see KDEN v1.2?

he's dreaming, there is only version 1.1 so far