FSDreamTeam forum

Products Support => Dallas FSX/P3D => Topic started by: FlyingOger on February 19, 2013, 09:18:37 pm

Title: Speed Bumps on Taxiway, adjacent to bridge near Terminal A ?
Post by: FlyingOger on February 19, 2013, 09:18:37 pm

Being guided to Gate A6 at nightfall, I crossed the bridge near the terminal just to encounter something looking like sand walls. Reduced visibility and (too) high taxi speed made my 747 jump and my virtual pax were more than a little annoyed.

So my question: Are those "speedbumps" real and intentional, or is that some mesh peculiarity? A following AI MD just went through these without any hassles...

Thanks, Torsten

Title: Re: Speed Bumps on Taxiway, adjacent to bridge near Terminal A ?
Post by: virtuali on February 19, 2013, 09:33:21 pm

Be sure you set the Mesh complexity and resolution as indicated in the "Design notes" section of the manual.

Title: Re: Speed Bumps on Taxiway, adjacent to bridge near Terminal A ?
Post by: FlyingOger on February 20, 2013, 06:47:56 am

Thanks, will check those settings tonight.

Just wondered if they were intentional because they were very evenly-spaced.