General Category > General Discussion

fsd airports and jetways

<< < (2/5) > >>

maca11:
Hello,

After parking of the aircraft and start of jetways they are moving but park 'entirely' of the plane (in real terns it would be something like 2 - 3 metres gao between jetway and airplane door. I am using 'standard' cs757 with no changes to configuration....
Anything I can adjust or set-up somewhere ?
many thanks !
JM

virtuali:

--- Quote from: maca11 on December 09, 2013, 06:36:53 pm ---After parking of the aircraft and start of jetways they are moving but park 'entirely' of the plane (in real terns it would be something like 2 - 3 metres gao between jetway and airplane door
--- End quote ---

Still not very clear: it's 2-3 meters off in *which* direction ? If it's just too much on the inside, but the height/lateral distance seems to be correct, that's still under what is considered to be normal using the default FSX animated jetways.

If, instead, it's 2-3 meters off in the lateral or height direction, than it means there's something wrong with you airplane configuration, perhaps GSX is not reading the CS757, possibly because you have a new variant which is not recognized yet. You could spot this one easily, if you pay attention how exits are named: if they use generic "Exit 1", etc, names, it means the airplane has NOT being recognized.

maca11:
OK, many thanks. I will try to check how doors are named.
Jetway is actually cca 2 metres off the plane horizontaly,  it is on the cca right height from base (similar to doors), but also in totally different place along the planes's fuselage... So in other words only what is OK is height all other 2 dimensions cca 2-3 metres off....
JM

pcubine:

--- Quote from: maca11 on December 09, 2013, 07:50:02 pm ---OK, many thanks. I will try to check how doors are named.
Jetway is actually cca 2 metres off the plane horizontaly,  it is on the cca right height from base (similar to doors), but also in totally different place along the planes's fuselage... So in other words only what is OK is height all other 2 dimensions cca 2-3 metres off....
JM

--- End quote ---

A screenshot of your issue would be helpfull.

Michael Cubine

maca11:
Hi, Ok, would do that, just don't know how to do that somehow easily...
regards
JM

Navigation

[0] Message Index

[#] Next page

[*] Previous page