General Category > Unofficial F/A-18 Acceleration Pack board
vLSO bugs and complaints
HornetMech:
I’m having the same issue that people running vLSO on P3D v3 are having with the program not recognizing FCLP sceneries. Only thing is, I’m running vLSO on FSX Gold Edition. I did make the switch from Windows 7 Home 64 bit to Windows 10 Pro 64 bit when I built my new machine this past April. No vLSO recognition of Lemoore, Oceana, or Meridian (IFLOLS not showing up at Meridian either). vLSO works as advertised with carriers. Any ideas or suggestions would really be appreciated. Thank you in advance.
vLSO ver. 0.8.2.11 beta
Flying the VRS Superbug (ver. 1.4.3.0) almost exclusively but having the same issue with all vLSO compatible aircraft.
TacPac ver. 1.4.3.0
TrackIR ver. 5.4.1.26786
FTX Global Base Pack
FTX Global Vector
FTX North America Freeware Packs
FTX Europe Freeware Packs
REX Essential Plus Overdrive ver. 3.8.2014.1126
FSX @ War ver. 1.0.1.0
FSX @ War Carrier and Convoy Planner ver. 1.3.3.0
Several MAIW packages
Paddles:
HornetMech,
The reason is simple - currently vLSO does not support Prepar3D v3, thus it does not read addon sceneries config files (where FCLP sceneries are defined). That's why no FCLP sceneries recognized under P3D v3...
FYI: I'm currently working on a new version which will support all present P3D versions.
HornetMech:
I really appreciate the response Paddles. But I'm not running Prepar3D. I'm running vLSO on FSX.
Paddles:
HornetMech,
I apologize for my inattentiveness. Well, could you run my utility FSchecker 5 to make sure it recognizes your sceneries? In the Summary window right click, select all, copy and then paste its output here in this thread or e-mail to me.
PhantomTweak:
I am far far from being a vLSO expert (I don't mess with it much. The AI LSO's it uses have it in for me, I swear. Very often :( ), but is it possible your sceneries are not someplace vLSO "looks" for them? I know FSX lets you put sceneries almost anywhere, but does vLSO only look in specific places, maybe? Most people put their additional scenery into the Add-On Scenery folder in the main FSX folder. Could it be, perhaps, that vLSO looks there for it, only?
I don't know where you installed your sceneries, or the IFOLS Trailer add-on (if you use it). Maybe, also, the priority needs to be higher or lower? Maybe you don't have high enough (or low) in the Scenery.cfg. Again, I am guessing here. I don't have the faintest idea if these guesses have any validity at all.
I hope Paddles will weigh in on this. I am just throwing WAGs out there.
Pat☺
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version