General Category > General Discussion

P3D - KORD issues/questions

(1/2) > >>

twharrell:
Having just moved over to P3D from FS9, I redownloaded my FSDT sceneries and installed all of them without difficulty. For the most part, KORD looks great.  I am having 2 separate issues, however.

1) Ground textures are bleeding through the apron, taxiways and runways. This is the only Chicago scenery I have added to P3D. 

2) I notice that runway 10/28 is not listed when I select 'create a flight' in SimLauncher or P3D. This holds true even if I run Makerunways.exe.

Any help is much appreciated.

Todd

virtuali:

--- Quote from: twharrell on April 06, 2013, 07:22:46 pm ---1) Ground textures are bleeding through the apron, taxiways and runways. This is the only Chicago scenery I have added to P3D. 
--- End quote ---

Nobody ever reported this problem, not at least specifically with P3D. I've just tested it now, and there are no bleedings.


--- Quote ---2) I notice that runway 10/28 is not listed when I select 'create a flight' in SimLauncher or P3D. This holds true even if I run Makerunways.exe.
--- End quote ---

Runway 10/28 is there and I can selected it in the create flight screen.

Both issues are likely caused by another scenery in conflict.

twharrell:
That's strange, because I have no other scenery installed.  And Estonia migrator is off.

Todd

virtuali:

--- Quote from: twharrell on April 06, 2013, 07:48:47 pm ---That's strange, because I have no other scenery installed.  And Estonia migrator is off.
--- End quote ---

You might not have a *scenery* installed, but many AI Traffic products install AFCADs, and the only possible explanation why you don't see a runway, is that you have another AFCAD in conflict. I assure you the AFCAD that comes with O'Hare has runway 10/28.

twharrell:
If I open P3D directly, Runway 10/28 is listed. If I use SimLauncher, it isn't.  The only AI I am using is WoAI.

Todd

Navigation

[0] Message Index

[#] Next page