General Category > General Discussion

GSX seems to be working on other AFCAD than FSDT

(1/4) > >>

kozmicelly:
Hi Virtuali,

GSX seems to be working on other AFCAD than FSDT's.

What I've done recently are as follows;

1. Changed the OS XP32 to Win7,64. (clean install on SSD)
2. Installed FSX+Accelerator.
3. Installed All FSDT airports but Hawiians which I don't have.
4. Installed UTX-USA and GEX-North America.

What happened then, (KLAX B68)

1. Follow Me Car goes through buildings to the gate.
2. Marshaller is standing about 10~20ft right from the yellow line.
3. Select KLAX B68 from FSX airport menu, then a aircraft sits on the right place, meaning on the yellow line.
4. Disabled UTX and GEX, but didn't work.
[Added] 5. At KFLL I got a GSX message saying "Could't find valid AFCAD data.....".

I know this seems to be happening because of other AFCAD installed.
But I didn't install any other sceneries except UTX and GEX.
I tried to check duplicate(s) by Airport scanner, it worked on XP32 but not on Win7, I got error messages.

What, do you think, is my option(s) to take to solve this problem?  

Thank you in advance.

Kozmic (RJTT)

kozmicelly:
Hi again,

Today I uninstalled every software relating to FSX and FSX itself.
And freshly installed only FSX, KLAX and GSX.
Tested the same procedure as my post above.
The result was the same, which means;

Using the airport menu of FSX, I went to KLAX B68 and tried to use GSX.
But GSX says something like "can't use GSX service in this position".

Then using GSX the gate menu, jumped to B68.
I could use GSX servies there, BUT I found my default A321 sitting about 45deg to the yellow line.

I can't guess what's the cause of this issue.

Any ideas?

Thank you

Kozmic

virtuali:
The "Customize parking position" option in GSX will tell you which AFCAD is in use by GSX.

kozmicelly:
Thanx !!

I'll give it a try and report it back.

Elly

kozmicelly:
At KLAX, the scenery file "APX16190.bgl" of FSX is used.

I know this file shouldn't be disabled, but I've tried it anyway.
As I guessed it, lots of error messege popped up, and the airport editor disappeared from the GSX menu.

What can I do ?

As for the airport scanner, there are 32bit version and 64bit version?
As I said in the first post, my AP Scanner gives me an error message.
Does this error message come from the wrong version?

If it's the case, how can I get another version?

Navigation

[0] Message Index

[#] Next page