General Category > Unofficial F/A-18 Acceleration Pack board
Dino Cattaneo F-14/T-45/F-35 News Update
Woogey:
That is a C. Less equipment.
dreaminsight:
i made Swiss repaints for the T-45C from Dino. Thread here: http://www.sim-outhouse.com/sohforums/showthread.php?t=88124 i am Mirage3. If any are intersted, The repaint can be asked by me at:spaless100100@gmail.com or sending a PM here.
Cheers
Dreaminsight
Tregarth:
I have downloaded Dino's latest update, it is very good. I have one question about the upfront keypad:
How do I input the ILS frequency using the keypad? I can "dial in" the heading and course using the HDG and CRS buttons and ENT but not the ILS / NDB frequency. (I cannot see an ILS button on the keypad.) Keying 112 onto the pad does not change the Cessna radio stack values. To change the frequency I have to use the Cessna radio stack which does not seem right.
Has anyone else had this problem and how have they solved it?
Thank you,
Tregarth
einherz:
--- Quote from: Tregarth on July 05, 2014, 04:20:56 pm ---I have downloaded Dino's latest update, it is very good. I have one question about the upfront keypad:
How do I input the ILS frequency using the keypad? I can "dial in" the heading and course using the HDG and CRS buttons and ENT but not the ILS / NDB frequency. (I cannot see an ILS button on the keypad.) Keying 112 onto the pad does not change the Cessna radio stack values. To change the frequency I have to use the Cessna radio stack which does not seem right.
Has anyone else had this problem and how have they solved it?
Thank you,
Tregarth
--- End quote ---
hope you found solve yet, only one way i know for ils in this craft is nav1 freq for carriers:), and for each other is keyboard use, something like that - key n after + - for change nav1 freq
if your question about carrier freq - unfortunately its work only with specific models, like dino cataneo's, aerosoft f14, etc
actually this is not work in carrier, just emulate it in modificated hud xml files
hope this help
Habu:
Flying the T-45 v2.52 doing traps on Javier's Nimitz, I can not adjust the course line on the HSI. Upon invoking the Javier Nimitz add-on with AI Carriers2 and tuning the TACAN, the HSI course digits and line snap to 180, which happens to be the Nimitz course. I can not change the course using either the HSI buttons or the right panel radio course knob. Anyone have advice re this issue??
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version