Products Support > GSX Support FSX/P3D

Pushback problems

<< < (2/2)

virtuali:

--- Quote from: Noble. on July 15, 2012, 10:04:11 pm ---Obviously this isn't an issue with GSX what-so-ever, but do you have any advice on the best way to remedy this?
--- End quote ---

You might try playing with the 9th, 10th and 11th parameter of the contact point, which are: Static Compression, Ratio of Maximum Compression to Static Compression and Damping Ratio

In the PMDG MD-11 they are set to:

1.10, 0.8, 0.725

for the nose gear, and

1.10, 0.9, 0.747

for all the other gears


--- Quote ---Also, if I modify the values in contact points in the aircraft.cfg will I need to modify the gsx.cfg for the MD-11?
--- End quote ---

No, the contact points in the aircraft.cfg are physical values, GSX.CFG values are related only to the visual model, and you are not changing that. As I've said already, there's no need for a GSX.CFG file with a fully supported airplane like the MD-11.

Ricochetv1:
It's not clear if or what fixed this issue. I'm having the same issue, el except that as I'm taxiing after having to slew the plane back to where it was after sliding across the ground, the brakes go into a permanent overheat condition.

Navigation

[0] Message Index

[*] Previous page