FSLab's Concorde-X

[boilerbill]

This setup uses the upper rear cargo hold, which is more visually dramatic than the lower one.


[aircraft]
nosegear = 12.05
refueling = 1
absoluteheights  = 1

[exit1]
pos = -1.1 23.5 4.2 0.0
code = 1
name = Exit 1L

[exit2]
remove = 1

[exit3]
remove = 1

[exit4]
remove = 1

[service1]
pos = 1.1 24.2 4.35 0.0
code = 0

[service2]
remove = 1

[cargo1]
remove = 1

[cargo2]
pos = 1.3 -12.15 4.2 0.0
code = 0
uldcode = BELT



Unless you have changed them, the default key sequences to operate the 3 doors are...

• Shift+Tab+1 for 1L (passenger boarding door)
• Shift+Tab+4 for 1R (catering door)
• Shift+Tab+7 for Upper Cargo door (catering door)

Exterior Views (the airport is KIND, which the Concorde visited a few times, so the equipment is supplied by other airlines):









Interior Views (from the front of the cabin):

[frerechris]

where to past/copy all this for Concorde X
In aircraft CFG or in anywhere else ??
Many thanks

[virtuali]

where to past/copy all this for Concorde X In aircraft CFG or in anywhere else ??

This post was from more than 1 year ago. The Concorde is internally supported by GSX so, there's no need for this file anymore to use the airplane, just to use the upper rear cargo hold instead of the lower one.

As the GSX manual explains, you can post the .CFG either in your airplane folder, together with the aircraft.cfg OR in the %APPDATA%\Virtuali\Airplanes\AIRPLANE_NAME (where airplane name is of course the name of the airplane folder)

[petakas]

I improved the GSX internally supported FSLabs Concorde.
- Added Lower Cargo Door (FSDT you did not spot it ehh ?   unless you know it or fly the FSL Concorde you won't see it, its in the belly)
- Adjusted a bit the Upper Cargo Door