General Category > Unofficial F/A-18 Acceleration Pack board

Manual Requested for the F/A-18 and all its capabilities...

<< < (2/2)

virtuali:

--- Quote from: JamesChams on May 12, 2008, 05:18:53 am ---1.  What does the EM CON annunciator on the HUD/radio panel used for and the D/L button on the autopilot do?
--- End quote ---

Both are not operational


--- Quote ---2.  Could you describe the RADAR symbology on the MFD RDR...
a.  What are the dull-green boxes - AI - Ships/Vehicles?
--- End quote ---

Since this it's an AA radar, the only things showed here are AI airplanes that are actually flying. The dull green boxes are, of course, the targets.


--- Quote ---What do the Carrots represent?
--- End quote ---

They give a visual representation of where the target is headed


--- Quote ---c.  Can you explains the numbering around it.  Are these examples of Alt, RNG, or Velocity
--- End quote ---

It was already explained here:

http://www.fsdreamteam.com/forum/index.php?topic=52.0


--- Quote ---3. What uses do the E/W, S/A and SENS on the MFD have?
--- End quote ---

Not much.


--- Quote ---a. Why do they say INOP (Inoperative)?
--- End quote ---

Because they are not modeled in this simulation.


--- Quote ---4. What does the ATTN INS switch do? 
--- End quote ---

Nothing.

JamesChams:
Dear Virtuali Staff,

  I hope that my posting of the YouTube Video or my questions/comments didn't offend you in any way.  I, merely, wanted to inform you of the exact problem I was having with the GPS & A/P during the approach phase of the flight to see if there was a known solution.

But, for the rest - Thank you!  This is a remarkable aircraft model and I hope that your F-14, "to be", will best this one too and include all the features of navigation, including the GPS, that were not included/tested with the F/A-18.

Now, I'll leave you alone to do what you do best and I will do the same.  ;)

Thank you very much and I'm patiently awaiting KJFK.

diga:
Hi,

I found how the DDI MFD Button from NORM to D-CTR works. Click with Mouse near the DDI and then move the mouse about 1-2cm away from the button, still holding the mouse button. Then with a bigger diameter rotate the mouse - this is how it can be change. try few times.

Navigation

[0] Message Index

[*] Previous page