Developer's Backdoor > GSX Backdoor

My bags!

<< < (2/3) > >>

Bruce Hamilton:

--- Quote from: msalo on February 25, 2012, 04:12:49 am ---That's where the bags go to be examined and all valuables removed before the bags are delivered to the terminal!!!  ;)
--- End quote ---

Commonly known as going through customs.   ;D

cdnavi8r:
Well, I completely recreated the AFCAD for Calgary's airport with vehicle links going in and out of the terminal.  I will test and post my result.  Fingers crossed

virtuali:

--- Quote from: cdnvi8r on February 25, 2012, 05:48:18 pm ---So what I would need to do is add vehicle links around the airport and also to and from every gate? I could also create some going into the terminal?
--- End quote ---

That would surely help them doing more realistic paths, and you could also simulate terminal dropping points for baggage that way.

However, even without any of them, GSX will still work, its vehicles will of course had to run over the taxiways, but they will work nonetheless.

cdnavi8r:
Alright gents,

Here's what I have so far. I have included all the vehicle links as the real counterpart shows them, in the AFCAD.  I even included links inside the terminal buildings where vehicles can enter and exit.

However, since I've included all the vehicle links, the baggage carts still drive to the taxi lines and drive away to the unknown "customs" area.  I have no idea what to do next  :(

virtuali:

--- Quote from: cdnvi8r on February 26, 2012, 01:40:54 am ---However, since I've included all the vehicle links, the baggage carts still drive to the taxi lines and drive away to the unknown "customs" area.  I have no idea what to do next
--- End quote ---

Your screenshot doesn't show all the airport (it might have been probably easier if you just posted the AFCAD itself, since it's likely smaller than the screenshots...), but from what I can see, you have some vehicles paths crossing taxiways.

Please, describe precisely a situation of which parking you selected, and which taxiways the vehicles crossed, and post the AFCAD so we can verify it.

Navigation

[0] Message Index

[#] Next page

[*] Previous page