Products Support > GSX Support FSX/P3D

No GSX service in ZRH?

(1/1)

windshear:
I just landed there, and there is no service ???

Also there is no pushback at flightbeam's SFO...

I still see the stairs move to the rear door in the NGX... I only need to jetway, how to make that work?

Thank you for your assistance!

virtuali:

--- Quote from: windshear on February 16, 2012, 12:01:04 pm ---I just landed there, and there is no service ???
--- End quote ---

Checked now, and everything is working normally. Have you renamed/removed the AFCAD that comes with Zurich ?

Which gate, exactly ?


--- Quote ---Also there is no pushback at flightbeam's SFO...
--- End quote ---

Checked now, and pushback it's there too. Which gate ?


--- Quote ---I still see the stairs move to the rear door in the NGX... I only need to jetway, how to make that work?
--- End quote ---

You can use the "Customize this parking position" option, but only for airports that don't come with their own customization.

windshear:
I checked... it is using the one GSX installed.

APX_LSZH.BGL

The older ones are all .BAK.

Will change the AFCAD to my original one to see which effect it has.

For Flightbeam I am using this one: KSFO_AFCAD_DS.BGL

It was an updated AFCAD... But was released by flightbeam.

Will test Zurich again when I get back home

BTW I checked your post on the new update, and I updated GSX while at the gate in AMS, heading to ZRH, so I suspect that this might be the reason for ZRH not working properly?

virtuali:

--- Quote from: windshear on February 16, 2012, 02:57:05 pm ---APX_LSZH.BGL

The older ones are all .BAK.

Will change the AFCAD to my original one to see which effect it has.
--- End quote ---

They are all correct, don't touch them.


--- Quote ---For Flightbeam I am using this one: KSFO_AFCAD_DS.BGL
--- End quote ---

This will have the effect of losing our customization, but it would still work as it was any default airport.


--- Quote ---BTW I checked your post on the new update, and I updated GSX while at the gate in AMS, heading to ZRH, so I suspect that this might be the reason for ZRH not working properly?
--- End quote ---

Your location when updating doesn't matter at all, you could update even when flying, if it's a minor update that doesn't require restarting.

Instead, be sure you installed the vehicles updates, because some missing model paths were fixed and, a missing model path creating a Simconnect error might block GSX.

Navigation

[0] Message Index