Products Support > GSX Support FSX/P3D

Activity - Open Hangar Door and NO Hangar

(1/2) > >>

firehawk44:
I have FSDT JFK installed and loaded my 737 NGX at Gate B31.  When I hit Ctrl+F12, I get the following message:



As you can see, there are no hangars nearby and I cannot get the startup sequence to load passengers, luggage, etc.  I have the latest updates installed.

Best regards,
Jim

virtuali:
Have you installed GSX AFTER the scenery ? If you reinstalled the scenery after GSX; you need to reinstall at least the Stand-Alone Addon Manager.

firehawk44:

--- Quote from: virtuali on February 12, 2012, 10:38:47 pm ---Have you installed GSX AFTER the scenery ? If you reinstalled the scenery after GSX; you need to reinstall at least the Stand-Alone Addon Manager.

--- End quote ---

GSX was installed AFTER FSDT JFK.  JFK has been installed for over a year.  I recently reinstalled the Stand-Alone Addon Manager as you indicated there was an upgrade.  Then I downloaded the latest version of GSX (1.1).  I did not uninstall GSX but installed the new version over the original version.

Best regards,
Jim

virtuali:
Does the Addon Manager show GSX in its addon list ? Do you have the "GSX Settings" menu under the "Couatl powered products" ?

firehawk44:

--- Quote from: virtuali on February 12, 2012, 11:31:38 pm ---Does the Addon Manager show GSX in its addon list ? Do you have the "GSX Settings" menu under the "Couatl powered products" ?

--- End quote ---

Yes to both questions. GSX is activated. However, I found what I did wrong and fixed it.  You evidently have to shut down the 737NGX to Cold and Dark before you can activate any services.  I shut it down and got the message to activate.  Fixed!  Thanks for your support!

Best regards,
Jim

Navigation

[0] Message Index

[#] Next page