Products Support > GSX Support FSX/P3D

Silly question on how to open the fsx standard 737s etc

(1/4) > >>

pete_auau:
Hi great product  just  downloaded  it  went  and  tried the  standard   fsx  737  to see if it  works    and  yes   it  does  but   since  i havnt flown the standard  fsx  aircraft  for ages   was wondering what  are the keys   to open the  doors  3  and  4 and  cargo  doors   since  it  wont let  me  finish  the loading  till i open  the  doors.  I  tried   shift  and  e   but that only  opens the  main  cabin door  1   thx  again

virtuali:
Default 737, A321 and 747 use the following commands, which are kind of standard for default:

Shift+E will open the main Exit
Shift+E followed by 2 in rapid succession will open both Cargo doors together
Shift+E followed by 3 in rapid succession will open all the doors on the right, for Catering

Default airplanes have shared animations, Cargo doors open together, and all the doors on the right open together too, airplane listed at "Level 2" in the this thread:

http://www.fsdreamteam.com/forum/index.php?topic=5481.0

Usually have independent doors animations, and GSX will work with their custom method of opening doors.

Sometimes you have to use the airplane configuration utilities to enable hotkeys, an example of this is the PMDG747: by default is configured to have all doors on the left and all doors on the right opening together with two hotkeys, but you *can* assign different keys to operate independently. The good thing is, even if you remap keys, it won't affect GSX, that will still work with that airplane.

pete_auau:
thx  for  that   and   what  can i say  about  gsx  is  wow  another  great  product  from   fsdt   team

Kurt:
Hi Umberto, I have a similar problem: after I'm ready for push-back I'm always asked to shut the doors 1 and 2 for the default B737. But all doors are closed except the cargo-doors on the right side. And when I push the keys the main door opens, when I repeat the Keys the main door close but not the cargo-doors.

virtuali:
Not a GSX problem, GSX only *reads* the door status, doesn't control the actual opening/closing operation. If you can't open/close them, it's because you aren't pressing the number 2 after Shift+E at the correct time, try doing it either faster or slower.

The command to open Cargo doors on the default airplanes it's NOT Shift+E+2. It's Shift+E FIRST, and THEN 2 (on the main keyboard, not on the numeric keypad), after a brief pause.

Navigation

[0] Message Index

[#] Next page