Products Support > GSX Support FSX/P3D
List of supported airplanes in GSX
virtuali:
--- Quote from: sugdenh on September 09, 2012, 02:17:13 pm ---Just before I buy the full version- does GSX work with any 3rd party airplane as long as it has the correct door information.
--- End quote ---
Yes. But for some 3rd party airplanes that use non-standard door commands, it might be tricky to know which variables they used to control the doors animations.
--- Quote ---Can I check whether planes have the information required and is it possible to add this information?
--- End quote ---
The list in this thread indicates all the airplanes already included in GSX.
--- Quote ---Is there a program I can use to set door locations etc?
--- End quote ---
Everything you need to add a new supported airplane is included in GSX, which has a dedicated graphical editor. This is of course explained in the manual, which you can read even before purchasing (since the download is free) and you can add support for a new airplane and learn how to use the airplane editor, without purchasing it too, since GSX works entirely for free at any FSDT and Flightbeam airport and on a couple of Trial default airports too.
sugdenh:
Thanks for your help! Will be lookin forward to adding gsx to the experience!
WilliamJSS:
Hello FSDT members and Devs.
I have a request if it would be possible.
Could we please look into getting the CookSky DC-9 supported for GSX? That would be great as this is my new favorite aircraft to fly.
Thank you for the consideration.
boilerbill:
--- Quote from: WilliamJSS on September 17, 2012, 12:12:08 am ---Hello FSDT members and Devs.
I have a request if it would be possible.
Could we please look into getting the CookSky DC-9 supported for GSX? That would be great as this is my new favorite aircraft to fly.
Thank you for the consideration.
--- End quote ---
No configuration file should be needed unless you want to change something. The DC-9 should work already as illustrated here...
In case your system doesn't have the correct configuration file, here is a copy of the default file that was created on my system:
[aircraft]
nosegear = 13.51
refueling = 1
[exit1]
pos = -1.60 11.47 0.39 0.00
code = 1
[exit2]
remove = 1
[exit3]
remove = 1
[exit4]
remove = 1
[service1]
pos = 1.56 11.50 0.39 0.00
code = 0
[service2]
remove = 1
[cargo1]
pos = 0.85 5.70 -0.68 0.00
code = 2
uldcode = BELT
[cargo2]
pos = 1.75 -7.25 -0.61 0.00
code = 2
uldcode = BELT
WilliamJSS:
Thank you! For some reason my door and the stairs were not lining up
Sent from my overpriced fragile iPhone using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version