Products Support > GSX Support FSX/P3D
List of supported airplanes in GSX
danwatto:
I'd love the J41, the ground crew are treating it like a GA at the moment, but oh yeah she is an airliner :)
If anyone has done it care to share your cfg?
Otherwise I suppose I'll have to figure out how to do it with that new tool
captjames747:
Will the Quality Wings 146 be supported, as at present no loaders or stairs appear.
Denzel:
--- Quote from: virtuali on August 19, 2012, 01:30:31 pm ---
--- Quote from: highflyer on August 19, 2012, 11:34:52 am ---Airplane support request: JustFlight BAE 146-200
--- End quote ---
With the new graphical Airplane Configuration utility, it should be very simple to add any airplane to GSX.
--- End quote ---
Hi Umberto, i'm experiencing some troubles with the new QWBAE146 + GSX...
I've configurated all the exits with Aircraft 3D editor tool and selected "BELT" as ULD and saved
But when i launch a debording sequence the "ULD Belt" doesn't appear...? same with "ULD AUTO"...
I've checked with NGX737 or Airbux X at the same airport same gate, the "ULD BELT" appear and works fine
so i'm lost...
Regards
virtuali:
--- Quote from: Denzel on August 25, 2012, 05:49:02 am ---Hi Umberto, i'm experiencing some troubles with the new QWBAE146 + GSX...I've configurated all the exits with Aircraft 3D editor tool and selected "BELT" as ULD and saved
But when i launch a debording sequence the "ULD Belt" doesn't appear...? same with "ULD AUTO"...
--- End quote ---
Already asked and answered here:
http://www.fsdreamteam.com/forum/index.php?topic=7189.0
Denzel:
--- Quote from: virtuali on August 25, 2012, 09:46:52 am ---
--- Quote from: Denzel on August 25, 2012, 05:49:02 am ---Hi Umberto, i'm experiencing some troubles with the new QWBAE146 + GSX...I've configurated all the exits with Aircraft 3D editor tool and selected "BELT" as ULD and saved
But when i launch a debording sequence the "ULD Belt" doesn't appear...? same with "ULD AUTO"...
--- End quote ---
Already asked and answered here:
http://www.fsdreamteam.com/forum/index.php?topic=7189.0
--- End quote ---
Thanx for replying i'm gonna see what i can do
Best regards
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version