Products Support > GSX Support FSX/P3D

List of supported airplanes in GSX

<< < (28/75) > >>

virtuali:

--- Quote from: thomas888b on April 15, 2012, 08:31:57 pm ---No, you misunderstand, I'm not sure why there are three staircases. Only two doors open.
--- End quote ---

It's not that I misunderstood: you wrote:


--- Quote ---when opening door 1, 3 doors open, I get 2 staircases.
--- End quote ---

That's why I said it's the opposite, and it IS what is supposed to happen: when you open Exit 1 with the default 747, you should see TWO doors open and THREE staircases. Is this is what you see ? If yes, that's how is supposed to work.


--- Quote ---Does AES configure the CFG file, I want to edit the doors on one plane, however, I'm not sure how to do it just editing the CFG using GSX's method.
--- End quote ---

AES configues its own .CFG file, that GSX can read too, but only if there isn't a better source of data for its config, the priority is as follows:

- If there's no config file at all, the data is taken from the aircraft.cfg and simconnect

- If there's an AES intelliscene.cfg file in the airplane root folder, it will take priority over the aircraft.cfg

- If the airplane is in the internal GSX database, it will take priority over the AES file

- If you made a GSX.CFG using the editor, it will take priority over the internal GSX databas

virtuali:

--- Quote from: fipsi on April 15, 2012, 08:00:56 pm ---Unfortunately, it doesn't work at all, I guess, with saying that the vehicles might not be 100% precise at the doors you still mean that they're quite close to the doors, but this doesn't fit with Thomas Ruth's Airbuses, no single vehicle is close to its supposed door.
--- End quote ---

This might happen if the exits are entirely wrong or even missing, this is usually the case of airplane ported over from FS9.


--- Quote ---I tried out the editor but, for instance, the cargo door 2 from the A346 doesn't even have coordinates which got shown up in the menu.  
--- End quote ---

This means that door doesn't exist in the aircraft.cfg OR it exists, but without coordinates.

Nothing that you couldn't fix anyway, you can add a section if it doesn't exits, and putting some ballpark numbers that might get you started, like this:

[cargo 2]
pos = 1.90 14.0 3.30 0.0
code = 2
name = Rear Cargo Door
uldcode = AKE

I made up values, but you should see something more or less in the rear position, it should't require more than a few tries to get it right on your airplane.

emendez:
+1 ATR 72-500 from Flight1

flythebest:
Ciao Umberto,

With all updates, is the Leonardo SH working level 2 with GSX ? I did just a try, loaded the airplane and all vehicules are in place but ground people are not working !! maybe you have implemented a way of making ground staff to be on strike lol !

For information, I have the 2008 version of maddog, don't think it changes something...

Regards

Mike

virtuali:
There's a Maddog configuration file in the Sharing area.

Navigation

[0] Message Index

[#] Next page

[*] Previous page