General Category > Unofficial F/A-18 Acceleration Pack board
vLSO Beta release
Paddles:
Oddly enough, but I didn't change anything about carrier/aircraft data acquisition code since version 0.1. Bummer... :-[
robertorizzo:
For now i'm going to enjoy my new toy, in a few days i'll try new paths, merging things in the vLSO folder hoping to use any new version. If I get results I'll tell you for your next releases. Bye.
Johan:
--- Quote from: fsxnavypilot on March 17, 2012, 05:28:08 pm ---Oddly enough, but I didn't change anything about carrier/aircraft data acquisition code since version 0.1. Bummer... :-[
--- End quote ---
Hi Serge,
First, thanks for all the improvements to the vLSO, I have been a follower since the very beginning.
I noticed that 0.6b is not working when I operate from Whitbey (KNUW) with ORBX Pacific North West scenery on. It is working when that scenery if off though....
Would there be an obvious reason of conflict between the two?
Just curious, so don't spend time unless the cause is obvious. I will try with previous versions of vLSO that I have kept.
Thanks again,
Johan
Paddles:
Johan,
Is your ORBX scenery Prepare3D compatible? I read on forums that using non-P3D addons under Prepare3D requires some manual intervention.
Johan:
--- Quote from: fsxnavypilot on March 18, 2012, 09:03:25 am ---Johan,
Is your ORBX scenery Prepare3D compatible? I read on forums that using non-P3D addons under Prepare3D requires some manual intervention.
--- End quote ---
I don't believe my ORBX PNW version is Prepare3D compatible. The P3D compatible version was announced on 1/5/12 and my install is older than that.
Thanks for your insight though. It doesn't bother me to do AC operations when this scenery if off. Your vLSO is great.
Thanks Serge,
Johan
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version