General Category > Unofficial F/A-18 Acceleration Pack board
vLSO Beta release
Paddles:
--- Quote from: pyroperson87 on February 07, 2016, 07:33:12 pm ---is there any chance you could add support for the RFN Creations Charles de Gaulle carrier in the next vLSO version?
--- End quote ---
No chance I'm afraid. :( Two reasons: 1) the RFN CDG model doesn't use FSX default OLS and 2) their current OLS is a gauge attached to the user's aircraft panel and currently my program can't communicate with panel's variables (so-called L: vars, wich control the ball and cut/waveoff lights of their OLS).
pyroperson87:
Bummer. :(
ESzczesniak:
I am having some problems using vLSO with the Aerosoft CV-63 Kitty Hawk (from the new F-14X Extended release). At the start of the flight I get a message "The CV63 support disabled (no FLOLS gauge installed)". Following this, I get the normal BRC and altimeter readings from vLSO. Can elaborate on what this message means and how to address.
Paddles:
ESzczesniak,
This message means that your aircraft doesn't have the FLOLS_CV63 gauge installed (or it was improperly installed). This gauge is required, because Aerosoft have implemented the real 3.5 degrees glideslope on their CV63 model, and without it you won't be able to see the meatball. That's why vLSO checks your aircraft's panel config to make sure this gauge is installed.
Please read the Aerosoft Vol 7 - Carrier Operations.pdf manual on how to install the gauge. However, people sometimes experience problems like this with it.
Hope this helps.
ESzczesniak:
--- Quote from: Paddles on March 18, 2016, 08:56:44 am ---ESzczesniak,
This message means that your aircraft doesn't have the FLOLS_CV63 gauge installed (or it was improperly installed). This gauge is required, because Aerosoft have implemented the real 3.5 degrees glideslope on their CV63 model, and without it you won't be able to see the meatball. That's why vLSO checks your aircraft's panel config to make sure this gauge is installed.
Please read the Aerosoft Vol 7 - Carrier Operations.pdf manual on how to install the gauge. However, people sometimes experience problems like this with it.
Hope this helps.
--- End quote ---
Thank you for the feedback. I had a brief thought that might be the case, but I was using the Aerosoft F-14X so I thought no way is that the problem. It seems that if I install it in any aircraft by their instructions, I get the same message. I'm thinking there must be an error I'm making.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version