General Category > Unofficial F/A-18 Acceleration Pack board

New DINO-T45C

<< < (2/8) > >>

neutrino:
OK, I have a suggestion ;D My fps always goes down a little near the boat, may be a couple of fps, and this is normal because the carrier is quite detailed and there is a lot going on on the deck. So, one way to minimize this effect is to use a clean configuration of the Nimitz, like with no single plane on it. Also, just to confirm that this is the problem, you can try a couple of passes with the default carrier - it's a very simple model, so there should be no frame rate drop.

3wire:
That sounds like a winner, I did change to the T-45C Carrier Qual config, I will try with a clean deck and with the default.

Letourn:
Latest version 2.1 Available at

http://indiafoxtecho.blogspot.com/

Thanks Dino and JR

wilycoyote4:
copy of part of readme for version 2.10 ----
VERSION 2.10
-Added instructor cockpit
-Changed glass material reflection for DirectX 10 compatibility
-Changed landing gear animation sequence to have a lower stance
-Added VT-86 repaint courtesy of Russel R. Smith
-Changed minor texturing flaws
-Minor fixes to the flight manual, added aft cockpit diagram and ejection seat details
-Activated "Bitching Betty" sounds by default GPWS, Over G, Low Fuel, albeit voice warnings
 are not currently linked to DEP data. GPWS Voice is set to 300 ft regardless of DEP and Low
 Fuel is not linked to BINGO value (Voice activates when fuel is 300lbs or less).

3wire:
Going back to the empty carrier helped. I flew 7-8 passes with no problem. Later when I was finished with the boat (I deleted it) I was flying around doing take offs and landings at different airfields around KNMM my world turned into a slide show for no apparent reason 4-10 FPS (just like it did around the boat). Out of curiosity I loaded up the default C-172 and my frame rates were between 120-200+

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version