General Category > Unofficial F/A-18 Acceleration Pack board

F/A- 18 Startup procedure is not real

(1/2) > >>

alemugny:
I working on the F/A-18 for the Swiss Air Force and i can say the procedure for start the engine in FSX is not correct.

The right procédure is:

1. Battery on
2. APU ON
3. Engine crank Right after the right engine start the Switch come again in the middle position.
4. Engine crank Leftt after the Leftt engine start the Switch come again in the middle position.
5. The apu is automatic shut after 10 min

Note: The caution APU ACCUM come if the APU accumulator is to low (under 3000 psi) or empty.
         In FSX this caution come if show turn the APU to off pisition is false.


Can you correct this problem for more realism ?

virtuali:
Any improvement to anything included in Acceleration has to be done by Microsoft.

The startup sequence is done according to how FSX normally works, there's no specific F/A-18 programming.

SUBS17:
So much easier than an F-16 its like getting in a car and turning the key. ;D

fael097:
id rather have other things working like RALT than a more realistic startup procedure..

virtuali:
To make things like RALT working, we would need some additional help from FSX engine like, in this case, being able to know the ground alt reasonably in advance (a certain point in front of the airplane), in order to give the needed reaction time to the autopilot, and that data is not available.

Navigation

[0] Message Index

[#] Next page