Products Support > GSX Support FSX/P3D

[Resolved] FS Labs Concorde and GSX settings

(1/2) > >>

Ray Proudfoot:
Hi Umberto,

P3D v5.3HF2 and the new 64-bit Concorde. FSL have integrated GSX into this new aircraft but have advised settings in GSX need changing to ensure correct operation.

The problem is these settings are different to those I use for my other aircraft specifically the PMDG737.

Having to remember and change these settings dependent on the aircraft in use is going to be a long-term nuisance. What is needed is a profile for each aircraft so the preferred settings can be made automatically.

This will also apply when Concorde is released for MSFS so a long-term solution would appear important. Could you implement such a system please?

srcooke:
I use Simstarter to use a required Couatladdons.ini Ray ;)

Ray Proudfoot:

--- Quote from: srcooke on August 20, 2023, 12:34:24 pm ---I use Simstarter to use a required Couatladdons.ini Ray ;)

--- End quote ---

Ah right, thanks Stephen. I didn’t realise it could be configured in it. Where should I look? I rarely change anything once configured.

srcooke:
Save copies of the configured Couatladdons.ini to location of your choice, use the 'Run Manager' in SS and configure different config sets eg STD and FSL.

Add File Operation and copy the required Couatladdons.ini file to the virtuali folder.

You can create seperate SS profiles and assign the required run configuration to each, or remember to switch the run as required.

Ray Proudfoot:
Thanks Stephen, much appreciated.  :)

Navigation

[0] Message Index

[#] Next page