Products Support > GSX Support FSX/P3D

Dual jetways not appearing

<< < (2/2)

virtuali:

--- Quote from: srcooke on December 30, 2022, 01:48:47 pm ---Quite possibly they are sunk below the ground or floating way in the sky.
--- End quote ---

If both jetways are made with GSX, it's not possible they would have different altitudes at the same gate. They should either be both sunk/floating, or they should both be correct.

srcooke:
Oh I'll grab a snapshot and show that they can indeed be at different elevations !

In fact as posted HERE

virtuali:

--- Quote from: srcooke on December 30, 2022, 03:20:55 pm ---Oh I'll grab a snapshot and show that they can indeed be at different elevations !

In fact as posted HERE

--- End quote ---

That's precisely why I said "at the same gate", which is not what is happening in your screenshot.

srcooke:

--- Quote from: virtuali on December 30, 2022, 03:30:57 pm ---
--- Quote from: srcooke on December 30, 2022, 03:20:55 pm ---Oh I'll grab a snapshot and show that they can indeed be at different elevations !

In fact as posted HERE

--- End quote ---

That's precisely why I said "at the same gate", which is not what is happening in your screenshot.

--- End quote ---

ok I'll try and grab a better image but some of those gates depicted are indeed dual entries, difficult with the elevation difference.

srcooke:
Aerosoft/Simwings LIMC in P3Dv5 CTRL-J jetways disabled and no SODE alternate installed. GSX2 configuration.

Gate 503 configured with two Aerotech Jetways on initial load only one at ground level the others are floating.

On applying the elevation fix via GSx Customization the second jetway is brought to ground level.

The elevation entry is logged in the .ini file.

Upon reloading the sim the jetways will again be split with several floating.

Navigation

[0] Message Index

[*] Previous page