Products Support > GSX Support FSX/P3D

Locking Gear

<< < (2/2)

G-AZZA:

--- Quote from: virtuali on August 28, 2022, 01:11:54 pm ---Why you think it's problem or a bug ?


--- End quote ---

Because it never done it until 2 updates ago!

But if you say that's how it is then that's how it is!

G-AZZA

virtuali:

--- Quote from: G-AZZA on August 28, 2022, 10:12:44 pm ---Because it never done it until 2 updates ago!
--- End quote ---

So any improvement we do to the procedures, we risk to be taken as a bug/problem, just because it never did that before ? Several knowledgeable users complained since a long time our previous procedure was wrong, and before allowing a truck anywhere near the airplane, you must insert the bypass pin first.

G-AZZA:

--- Quote from: virtuali on August 28, 2022, 11:08:51 pm ---
--- Quote from: G-AZZA on August 28, 2022, 10:12:44 pm ---Because it never done it until 2 updates ago!
--- End quote ---

So any improvement we do to the procedures, we risk to be taken as a bug/problem, just because it never did that before ? Several knowledgeable users complained since a long time our previous procedure was wrong, and before allowing a truck anywhere near the airplane, you must insert the bypass pin first.

--- End quote ---

OK. My point is that the bypass pin is inserted in the nosewheel, so why does the engineer go the centre of the aircraft not the nosewheel?

G-AZZA

fnav77:
Similar strange issue I have on P3D v5, there are two mechanics standing for the push. One walks along the aircraft during the push (which is normal), the other one just stays at the starting point of the push and does not move at all. That 2nd dude was not there before. Is this normal?

Navigation

[0] Message Index

[*] Previous page